Leapmotion & DSPIC

[Said-Okto]

hi every body
i'm working in an Oktokopter project. the teacher recommands the use of dspics in the embedded circuit board (because they are fast). is there possibilities to have an interface between leapmotion and the dspic.

[Joe_Ward]

People who have done similar projects have used a computer to run the Leap Motion software (which currently runs on Windows, Mac, and Linux), and write an application to translate hand motion into commands for the remote-controlled vehicle. These commands then need to be translated into physical control signals (e.g. IR or radio frequency).

[Said-Okto]

I can unterstand that is possible to use dspics. there is no constraints?

[Joe_Ward]

Where does the DSPIC micro controller fit into the process I described above? As long as it is after the custom program you write to interpret the Leap Motion tracking data, then any constraints are on non-Leap portions of the project. For the Leap Motion part, you just need a computer that meets the minimum requirements.

[Said-Okto]

ok thank you for your collaboration