Leap on the table with Oculus DK2

[andreimai]

Hi,

I just got my LEAP Motion sensor, and i'm testing some Beta VR apps from the store, but I don't have the Oculus Mount.
Any way I can run apps with the LM on the table instead on the oculus? Because when I was using the hands were inverted, in a way that I can play normally?

[katem]

Hi @andreimai --

As most of the VR demos are optimized for top-down tracking, I would not recommend placing the Controller on a table for use. One thing to not is that while an official mount makes the setup cleaner, it's certainly not required. Duct tape works just fine. Check out the Unofficial Mount Thread for more ideas. Also, if you happen to have access to a 3D printer, the files are available for free right here.

[GeraldT]

please try out http://gterveen.itch.io/press-bird-to-play - I made it for seated VR and a desk positioned Leap