Hi, recently I bought a new Leap Motion off of Amazon and installed the latest Orion software. At first, it didn't work, however after running the firmware reset tool it worked, albeit not perfectly due to a bad calibration, for a while. However, after shutting my pc off and turning it back on, it doesn't work at all.
The light on the Leap motion isn't illuminated, and I can't see the LED's on the inside glowing either. The system tray icon is black, and clicking 'Resume Tracking' does nothing.
In the settings window, Service Status says 'Connected', but Device status remains 'Disconnected'. The software log only shows the line, [20:54:40] [Info] Connected to Leap Service
.
I attempted the firmware reset tool, again, however now it gets stuck on the line [21:12:17] [Info] ResourceHost running
I've tried restarting my PC, re-installing the leap motion software, restarting the service, manually installing the drivers, using the firmware reset tool multiple times, switching USB ports, and nothing seems to be working. I have the leap plugged into a USB 3.0 (I believe) port on the back of my PC, using the extension cable to reach my VR headset where it's attached.
Any suggestions? Thanks