Hi Leap Community,
today i received my leap controller in my first package from the Looking Glass Kickstarter Pledge.
After i installed the Leap software 5.0 the software was stuck in a Update loop trying to install the newest frimware. After i installed the driver manually that is in the Install folder, it updated the Firmware but failed to load the calibration, on the right side it says its not connected and the Calibration status is bad. The icon on the taskbar is orange, saying i should recalibrate the leap controller, but when clicking this option on the troubleshooting page it shows me i should connet the controller. I also tried to reinstall the firmware with the firmware resetter but that doesnt work either, saying i should connect the leap controller. Any ideas how to fix this? I thank you for the Help!
[21:04:17] [Info] Connected to Leap Service
[21:04:16] You must recalibrate your device (Settings -> Troubleshooting)
[21:04:16] Unhandled exception: Failed to load calibration.
[21:04:16] Scorch exception: Failed to load calibration.
[21:04:17] Tearing down WinUSB
[21:04:17] Leap Motion Controller disconnected: LP43878335045
[21:04:17] [Warning] Your Leap Motion Controller may not be functioning optimally. Please recalibrate (Settings -> Troubleshooting).
[21:04:28] Initializing WinUSB
[21:04:28] Initialized WinUSB
[21:04:28] Leap Motion Controller detected: LP43878335045
[21:04:28] Firmware is up to date.
[21:04:28] [Info] Tracking resumed
[21:04:28] You must recalibrate your device (Settings -> Troubleshooting)
[21:04:28] Unhandled exception: Failed to load calibration.
[21:04:28] Scorch exception: Failed to load calibration.
[21:04:28] [Info] Tracking paused
[21:04:28] [Warning] Your Leap Motion Controller may not be functioning optimally. Please recalibrate (Settings -> Troubleshooting).
[21:04:28] Tearing down WinUSB
[21:04:28] Leap Motion Controller disconnected: LP43878335045
[21:13:09] Initializing WinUSB
[21:13:09] Initialized WinUSB
[21:13:09] Leap Motion Controller detected: LP43878335045
[21:13:09] Firmware is up to date.
[21:13:09] You must recalibrate your device (Settings -> Troubleshooting)
[21:13:09] Unhandled exception: Failed to load calibration.
[21:13:09] Scorch exception: Failed to load calibration.
[21:13:09] [Warning] Your Leap Motion Controller may not be functioning optimally. Please recalibrate (Settings -> Troubleshooting).
[21:13:09] Tearing down WinUSB
[21:13:09] Leap Motion Controller disconnected: LP43878335045
Leap Motion Firmware Reset tool
____________________________________________________
| |
| Please select "Pause Tracking" in the Leap |
| Motion Tray Icon. |
| |
| Press Enter to continue. |
|____________________________________________________|
Please plug in your Leap Motion Controller.
[21:20:59] [Info] ResourceHost running